Freestanding Scaffolding

INTAKS Freestanding scaffold has the benefit of variable spans, uniform platforms and quick assembly. Plus the versatility required for almost any building site or terrain. With strong but light aluminium and many tool-less components, assembly and transport takes far less time than alternatives.

Get In Touch

Please fill out the form below

Installation process

As with other INTAKS configurations, install follows an orderly, sequential and easy to complete process:

  1. Lay out Soleboards and Screwjacks where Standards are required.
  2. Configure support frames for the bottom platform with tool-less Transom and Standards.
  3. Build first bracing bay.
  4. Install remaining support frames.
  5. Install platform with Interlocking Planks.
  6. Install Handrails using tool-less Spring Clip mechanism.
  7. Install Toeboards using tool-less Toeboard Plank Clips.
  8. Configure and install Standards and Transoms for the next level.
  9. Install Interlocking Planks on next level.
  10. Create Ladder access and install Swing Gate.
  11. Install diagonal face braces, rakers and ties where required.
  12. Install Toeboards on next level.
  13. Complete final checks and handover to site manager.
  14. Dismantle process is the reverse to installation.

Components

Components are strong and throughtfully designed.

For handrails:

  • Handrail Tube (part #HR4 to HR#6)
  • Handrail Joiners/External Sleeve Couplers (part #1165/#SES)
  • Square Spring Clips (part #1146)
  • Fixed 90° Couplers (part #SFC) and/or Swivel Couplers (part #SSC) – for joining handrails at corners
  • Transom (part #1201 or #1203) – for ends of platforms
  • Handrail Post (part #1101) – for safely installing handrails on upper levels

For each pair of vertical posts and transoms:

  • 2 x Soleboards (part #ISB)
  • 2 x Screwjacks (part #SSJ450 or #SSJ620)
  • Extenders (part #1144/#1160)
  • Standard Arms and Standards (part #1172 to 1181)
  • Transom (part #1201 or #1203) and/or H-Frame Brackets (part #1150)

For platforms:

  • Interlocking Planks (part #ILP3 to ILP6)
  • Plank Staples (part #1158)
  • Plank Clamps – Single (part #1087) / Double (part #1080) / Tube (part #1079)
  • Toeboards (part #1210)
  • Toeboard Clips – Plank (part #1211)

Other:

  • Lock Pins (part #1182)
  • R-Clip (part #1900)
  • Ladder (part #LAD3.6/#LAD5.4)
  • Swing Gate (part #SG)
  • Tube – for Ledgers, Diagonal Face Braces, Rakers, Raker Braces, Ladder Support and Ties

Note: exact components required will vary depending on set-up and site specific requirements

Scaffold / edge protection equipment & solutions

Please fill out the form below