Freestanding Gables

This configuration utilises the same components as INTAKS Freestanding to create a gable scaffold. Typically built to stand alone after the main scaffold is removed. Wide spans and flat, uniform platforms, with fewer obstructions to get in the way

Installation process

Install of Freestanding Gables follows a similar process to install of the Freestanding configuration:

  1. Lay out Soleboards and Screwjacks where Standards are required.
  2. Configure end support frames.
  3. Configure middle support frames.
  4. Install support frames and diagonal face brace.
  5. Install remaining support frames.
  6. Install platform with Interlocking Planks.
  7. Install Swing Gate Handrail Post.
  8. Install Handrails using tool-less Spring Clip mechanism.
  9. Create Ladder access and install Swing Gate.
  10. Install rakers and ties.
  11. Install Toeboards using tool-less Toeboard Plank Clips.
  12. Complete final checks and handover to site manager.
  13. Dismantle process is the reverse to installation.

Components

Components used are the same as for the Freestanding configuration:

For handrails:

  • Handrail Tube (part #HR4 to HR#6)
  • Handrail Joiners/External Sleeve Couplers (part #1165/#SES)
  • Square Spring Clips (part #1146)
  • Fixed 90° Couplers (part #SFC) and/or Swivel Couplers (part #SSC) – for joining handrails at corners
  • Transom (part #1201 or #1203) – for ends of platforms
  • Handrail Post (part #1101) – for safely installing handrails on upper levels

For each support frame:

  • 2 x Soleboards (part #ISB)
  • 2 x Screwjacks (part #SSJ450 or #SSJ620)
  • 2 x Extenders (part #1144/#1160)
  • 2 x Standards (part #1178 to 1181)
  • 3 x Transoms (part #1201 or #1203)

For platforms:

  • Interlocking Planks (part #ILP3 to ILP6)
  • Plank Staples (part #1158)
  • Plank Clamps – Single (part #1087) / Double (part #1080) / Tube (part #1079)
  • Toeboards (part #1210)
  • Toeboard Clips – Plank (part #1211)

Other:

  • Lock Pins (part #1182)
  • R-Clip (part #1900)
  • Ladder (part #LAD3.6/#LAD5.4)
  • Swing Gate (part #SG)
  • Tube – for Ledgers, Diagonal Face Braces, Rakers, Raker Braces, Ladder Support and Ties
  • Butt Brackets (part #1143)

Note: exact components required will vary depending on set-up and site specific requirements

Scaffold / edge protection equipment & solutions

Please fill out the form below