Parapet Clamp

Parapet Clamps allow edge protection to be installed on parapets up to 550mm wide, without drilling or fixing to the building surface. With a short install and dismantle time, your project can move ahead on schedule.

Installation process

Straight-forward, systematic, install process allows rapid completion of install by a two person team:

  1. Brackets, Standard Arm, Handrail Post Bracket, and Handrail Post pre-assembled on the ground. No tools required.
  2. Working from EWP, installer positions pre-assembled unit and packers on the parapet.
  3. Unit Clamped into position by tightening Threaded Rod.
  4. Installer on the ground hands up 6m handrail tube to EWP. Each handrail tube weighs only around 6kg.
  5. Handrails secured to Handrail Posts using tool-less Spring Clip mechanism.
  6. Complete final checks and handover to site manager.
  7. Dismantle process is the reverse to installation.


Components are sturdy, robust, quickly assembled, and can be used with other configurations.

For handrail:

  • Handrail Tube (part #HR4 to HR#6)
  • Handrail Joiners/External Sleeve Couplers (part #1165/#SES)
  • Fixed 90° Couplers (part #SFC) and/or Swivel Couplers (part #SSC) – for joining handrails at corners

For each post:

  • 1 x Handrail Post/Swivel Handrail Post (part #1101/#1102)
  • 1 x Handrail Post Bracket (part #1092)
  • 1 x Standard Arm (part #1172/#1173/#1174/#1175)
  • 2 x Parapet Brackets (part #1152)
  • 1 x Threaded Rod (with 2 x Lock Nuts) (part #1245/#1260/#1275)
  • 3 x Lock Pins (part #1182)
  • 3 x R-Clips (part #1900)

Note: exact components required will vary depending on set-up and site-specific requirements. 25mm timber packer (not supplied) can be used to prevent deflection, if required.

Scaffold / edge protection equipment & solutions

Please fill out the form below